monarch1973
Plastic
- Joined
- Jan 22, 2022
Hey all. I have always used my vertical mill in the vertical position. I have a cast front tractor differential housing that the mounting ears are worn heavily. I plan to bore them out to 2 3/4" with an end mill, and press a bushing in to bring it back to original. Its pretty big and heavy, and I cannot figure out a good way to fixture it so I can mill it out vertically. If I was able to turn my head 90 degrees to be horizontal, I could just set the housing on my table and bore them out. Its a knock off Grizzly brand bridge port style.