dalt.deuel
Plastic
- Joined
- Apr 19, 2018
Hi all,
i am getting wire dig in at the internal corners on my burn programs. When i run my 3d simulation everything looks fine. When it is wire burned on our mitsubishi mv1200s (md pro-3)it has dig in. It is occuring on ruled surface burns as well as straight through burns.
I am programming using opticam
4 passes
.008" wire
2 degrees
i have tried to put .005" radii in the corners as well as running them with sharp corners programmed and getting the same result.
Is this a programming issue? Is there a setting on the machine i need to adjust?
Any and all information helps.
i am getting wire dig in at the internal corners on my burn programs. When i run my 3d simulation everything looks fine. When it is wire burned on our mitsubishi mv1200s (md pro-3)it has dig in. It is occuring on ruled surface burns as well as straight through burns.
I am programming using opticam
4 passes
.008" wire
2 degrees
i have tried to put .005" radii in the corners as well as running them with sharp corners programmed and getting the same result.
Is this a programming issue? Is there a setting on the machine i need to adjust?
Any and all information helps.