jeffers
Cast Iron
- Joined
- Aug 24, 2007
- Location
- Rhode Island
Hi,
I am looking for some change gears to cut a worm gear for my lathe restoration.
I need 12 DP, 14 1/2 pressure angle, 1 1/8" bore, 11/16" width.
Looking specifically for the following tooth counts 60, 55, 35 and 30.
They are change gears for a DSG 13 x 30.
Alternatively if anyone is prepared to loan them then that would work too!
I am looking for some change gears to cut a worm gear for my lathe restoration.
I need 12 DP, 14 1/2 pressure angle, 1 1/8" bore, 11/16" width.
Looking specifically for the following tooth counts 60, 55, 35 and 30.
They are change gears for a DSG 13 x 30.
Alternatively if anyone is prepared to loan them then that would work too!
