WTB thru bolts for electric motor

[indychuck]

I'm in need of 3 thru bolts for my repulsion induction electric motor.

The size of the thru bolt is 5/16 - 18 and 11 3/4 inches in length.

Anyone have any good resources on who has/manufactures these without a minimum order?

Thank you

 

[Milland]

McMaster-Carr

Not cheap or matching OEM, but will work and last forever.

Otherwise go with allthread and nuts. Still not OEM, but very cheap and easy to configure.

 

[dalmatiangirl61]

Allthread or some hardware store round stock, cut to length and thread the ends.

 

[DDoug]

If you have the clearance thru the core, a nice touch is to add some heat shrink tube in the middle section of the all thread.

 

[fciron]

I dunno about these homebrew solutions, fellas. It is a repulsion induction motor, ya know. ;-)

 

[dalmatiangirl61]

I dunno about these homebrew solutions, fellas. It is a repulsion induction motor, ya know. ;-)

Just make sure the lathe is on a north/south alignment with the headstock on north end while turning them, it makes sure the electrons have the proper polarity.

 

[moonlight machine]

I dunno about these homebrew solutions, fellas. It is a repulsion induction motor, ya know. ;-)

So T F what.