camaro_dan67
Cast Iron
- Joined
- Dec 4, 2009
- Location
- N.E. Pa.
The encoder connector on the motor has 17 pins.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Can I check signals with power on and the estop in if I unbolt the motor and lay it over on its side?
Can I check signals with power on and the estop in if I unbolt the motor and lay it over on its side?
Ok here is the latest. Tonight I took the motor off and looked at it carefully. I also found an older picture I had of the machine. I noticed in the picture the nameplate on the stator was in the front of the machine and the cables went twards the back of the machine.
What I actually had was the nameplate to the side of the machine and the cables out the back. I straightened this out and aligned my scribe marks as close as possible. I put the motor back on and the servos came on with no problem. I held the qp and cancel buttons down and homed the machine. Everything seemed to function normal but when I move the z up or down at different spots in the travel the z gets a buzzing sound. If I move the z up or down an unspecified amount it would stop buzzing. I could handle jog or rapid to different z locations sometimes it would buzz sometimes not. What is causing this? Do I need to try tweaking the parts of the motor more? Is my motor shot? It did have oil in it the first time I took it off.
How do I time the magnets to the brushes.
Notice
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.