Dan B
Hot Rolled
- Joined
- Feb 18, 2006
- Location
- Ontario, Canada
We are attempting to write a wash program using a spindle mounted fan. The fan is supposed to start at 2000 RPM and then ramp up to 8000 RPM maximum. However, if I put a higher spindle speed in with a tool call (to the same tool) the spindle stops for a half second before starting up again. That defeats the purpose of ramping up the RPM. Is there a way in Heidenhain code to add a higher spindle RPM without the spindle briefly stopping?
Thanks,
Dan
Thanks,
Dan