Bill D
Diamond
- Joined
- Apr 1, 2004
- Location
- Modesto, CA USA
I need to make a tablesaw arbor to match a female taper in my saw. How do I match this taper? If it was not threaded I would blue the taper and check the fit. Being threaded any blue will smear around. My plan is to swing the lathe compound to match my sample.
I suppose I could make a sample piece without the threads first. the depth of seating into the taper does not matter. I do not have any good way to measure the angle. I do not care what the angle is just that my piece matches the angle, what ever that angle may be.
the attached photo shows one similar to what I have to make. The taper may be slightly different, but similar angles, If not the exact same angles.
Bill D.
I suppose I could make a sample piece without the threads first. the depth of seating into the taper does not matter. I do not have any good way to measure the angle. I do not care what the angle is just that my piece matches the angle, what ever that angle may be.
the attached photo shows one similar to what I have to make. The taper may be slightly different, but similar angles, If not the exact same angles.
Bill D.