Hi,
I am wanting to cut and then thread two pieces of aluminum pipe. OD is 1", ID is 0.8". I would inside-thread one piece and outside-thread the other so that the two pieces will screw together, essentially recreating the pipe. There will be no load or stress on this junction - project is decorative in nature.
Question - is the 0.2" delta between OD and ID enough to allow adequate inside and outside threads?
Question - what TPI would you recommend?
Thanks in advance,
D
I am wanting to cut and then thread two pieces of aluminum pipe. OD is 1", ID is 0.8". I would inside-thread one piece and outside-thread the other so that the two pieces will screw together, essentially recreating the pipe. There will be no load or stress on this junction - project is decorative in nature.
Question - is the 0.2" delta between OD and ID enough to allow adequate inside and outside threads?
Question - what TPI would you recommend?
Thanks in advance,
D