Nikolaiownz
Aluminum
- Joined
- Feb 10, 2018
Hello
I bought a tos sn 500s lathe that had a few problems.
Ive leveled the lathe fairly good and it still turns a taper of 0.15mm over 120mm right infront of the spindel. that tells me that the spindel is out of aligenment right?
I put in a new 3 jaw chuck because the old one was junk.
so the question is anyone know where there is some adjustment for the spindel on the lathe? i got some manuals but nothing about it in thoes.
i will see if i can snap some pictures on the lathe today
I bought a tos sn 500s lathe that had a few problems.
Ive leveled the lathe fairly good and it still turns a taper of 0.15mm over 120mm right infront of the spindel. that tells me that the spindel is out of aligenment right?
I put in a new 3 jaw chuck because the old one was junk.
so the question is anyone know where there is some adjustment for the spindel on the lathe? i got some manuals but nothing about it in thoes.
i will see if i can snap some pictures on the lathe today