Just made this chip pan holder and back splash from an old steel table. Almost operational. Yes, that is an original 1929 3 C collet box from South Bend.
That is a "Purdy" little thang.
I had to take a new job in Feb of this year, and the work load and over time is killing me.
I have the mock-up cross-feed bushing done and need to attempt to fit the screw/dial/handle under the compound
to see if I can get a 2 inch dial on it. I'm still working on it just really slow. The first one is promised to Allan
for his Junior, you can have no 2 to test, I'll trade for dimensions and photos of the collet box...
If I have to change the length of the screw, I'll send that too.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.