What's new
What's new

Info on YG1 I-Xmill

Was wondering if anyone used these and what do you think

Why don't you tell us ?
From the OP's info page:

Basic Information
About slyfoxtool
Country:UNITED STATES
State Province: Michigan
Interests:learning how the tools I sell are used
Occupation:Owner
 
Last edited:
The YG3 ZX~^¥ mill is much nicer... less balsa wood and more aluminum in the frame
 
Mr. Slyfoxtool, I was a huge fan of YG-1, great prices and good endmills. Then I ran into Cobra Carbide at a trade show, found out they are American made, and they are made in Riverside Ca. the same town I work in. I tried them out and they cut better and are cheaper. Google Cobra Carbide, YG-1 users should give them a try. Hope this helps.
 
Cynical old machinist time - have we another cutter vender joining this spam fest?

NO, no shill here. Just thinking this guy was spamming/shilling so if someone was going to take him seriously, I thought I would give them a good source to try. So sorry I am not making any money off of Cobra Carbide. Heck If someone else want's to add another vendor I'd like to see them. As I said I have used YG-1 for years, I am now using Cobra instead. Sorry to have set off all the spam/BS meters.
 








 
Back
Top