Hi, I have a VF3 and I'm a total newbie to programming. Im making a part and at the end of the program when the part is done
the table stays where the last cut ended. How do I get it to go to the door so I don't have to manually jog it to change the part out? What should the line of code look like at the end? Here is the code from the last tool used.
( TOOL 10: 1.5 DIA. ROUND OVER )
S7500M3
G90G54G0X-.559Y-.0044
G43Z1.H10M8
Z.5
G1Z-2.25F50.
G42X-.6575Y.0127D10
G2X-.7389Y.1284I.0171J.0985
I.7389J-.1284F100.
X-.6233Y.2098I.0985J-.0172
G40G1X-.5248Y.1927
G0Z.5
G91G28Z0.M9
G90X0.Y0.M5
M30
the table stays where the last cut ended. How do I get it to go to the door so I don't have to manually jog it to change the part out? What should the line of code look like at the end? Here is the code from the last tool used.
( TOOL 10: 1.5 DIA. ROUND OVER )
S7500M3
G90G54G0X-.559Y-.0044
G43Z1.H10M8
Z.5
G1Z-2.25F50.
G42X-.6575Y.0127D10
G2X-.7389Y.1284I.0171J.0985
I.7389J-.1284F100.
X-.6233Y.2098I.0985J-.0172
G40G1X-.5248Y.1927
G0Z.5
G91G28Z0.M9
G90X0.Y0.M5
M30