SShep71
Hot Rolled
- Joined
- Sep 17, 2014
- Location
- San Diego, Ca
I am clearing out room in my one cabinet, these endmills are just stock that I kept from previous jobs and such. There are a lot of types and sizes here. The smallest diameter is 1/16, the largest diameter is 1-1/4", there are reduced shank, coated, 2 fl, 4 fl, 6 fl, some tapered , some radiused, some are brand new, some are used. This is perfect for a home garage machinist where you are learning, learning with carbide is a hard lesson, just my opinion it isn't worth anything past that. I am asking $150.00 plus 25.00 for USPS shipping.
I can provide some more information but I am not going to list every single endmill out, I just do not have time right now.
Just a note, I am leaving for work on the 10th and will not be back until the 16th so there will be a delay if you buy/pay after that.
I can provide some more information but I am not going to list every single endmill out, I just do not have time right now.
Just a note, I am leaving for work on the 10th and will not be back until the 16th so there will be a delay if you buy/pay after that.