What's new
What's new

Acer 1020 hudraulic surface grinder crossfeef

Stexas75

Plastic
Joined
Jul 19, 2019
I have an Acer 1020 ags hydraulic. The auto cross feed only works if I hold down the button on the control panel. I can put it in hand mode and move it back and forth. When put in auto it only moves the amount I set it to but like I said I have to hold fown the button to keep it going. Any insights or things to check would be greatly appreciated
 
J&S Valve in Oklahoma bought a Kent Grinder also made in Taiwan and I was there and used the grinder and I could not get the cross feed to work, could get the table feed to work when I pressed the feed button. Then one of the machinists showed me I had to press the feed button 2 times to get the cross feed to work. Seemed weird but it worked. Give that a try.
 
Hi,

Think it could also be a faulty relay.

If you have two of the same type in the machine try swapping them and see if the problem moves.

Greetings Peter


Verzonden vanaf mijn iPhone met Tapatalk
 








 
Back
Top