laminar-flow
Stainless
- Joined
- Jan 26, 2003
- Location
- Pacific Northwest
So you have a piece that is flat. At least you think it is flat, probably within .001 or so, and you need to get it on the mag chuck and start grinding.
What are some of the best methods to get the wheel down to the part without:
A: Taking forever by sneaking up on it in .00025 increments...
-or-
B: Sending the part into orbit, trashing the wheel, and messing up the surface of the chuck.
I have a few methods I use but I'm sure there are better ones.
What are some of the best methods to get the wheel down to the part without:
A: Taking forever by sneaking up on it in .00025 increments...
-or-
B: Sending the part into orbit, trashing the wheel, and messing up the surface of the chuck.
I have a few methods I use but I'm sure there are better ones.