Cphockey16
Plastic
- Joined
- May 28, 2020
Hey guys. Hate to start a new thread but couldn't find anything that quite answers my question.
I'm an apprentice - just started surface grinding recently. I have to finish the length on some 1.25 in pins. I was wondering, do you guys have any strategies for hogging material without coolant? Everything I've ground up to this point I've been taking my time - .0001-.0008 on downfeed per pass. I've got about .040 to take off these pins - using a 46 H 0.5 in wheel. Can I get away with taking .002-.003 a pass while roughing, so long as I let them sit and cool? Or will they get too hot?
Thanks!
I'm an apprentice - just started surface grinding recently. I have to finish the length on some 1.25 in pins. I was wondering, do you guys have any strategies for hogging material without coolant? Everything I've ground up to this point I've been taking my time - .0001-.0008 on downfeed per pass. I've got about .040 to take off these pins - using a 46 H 0.5 in wheel. Can I get away with taking .002-.003 a pass while roughing, so long as I let them sit and cool? Or will they get too hot?
Thanks!