plastikdreams
Diamond
- Joined
- May 31, 2011
- Location
- upstate nj
So today was my first suare at grinding 304ss. My what an experience. I had my best results with 2-3 tenth downfeed and 40-60 thou cross feed. Forgive me I can't remember the wheel grit, I think it was 38. I used a piece of "lip balm" wax as my coolant but man it it thermally sensitive. It was a piece of prodec 304ss 5x7 I brought it down to .756.
Just wondering on some suggestions based on what I provided above. The 4 sides were wire cut so I was able to use 3 .250 thick parallels to hold it tight.
Just wondering on some suggestions based on what I provided above. The 4 sides were wire cut so I was able to use 3 .250 thick parallels to hold it tight.