TBD
Plastic
- Joined
- Aug 3, 2006
- Location
- Miami, FL USA
Hi All I have a question for the experienced guys here
I have a FG5000 Van Norman Flywheel Grinder but the grinder motor which is 5HP 3600 RPM
Went Brock but I have an almost identical spare motor the only problem is that this one is 1800 RPM could someone tell what will be the difference if I'm not wrong I think the finish
Will be rough using the 1800 RPM cuz is the same horse power then I really don't know if the grinding stone will last longer or shorter.
All comments will be highly appreciated .
Best Of All to all of you guys.
TBD
I have a FG5000 Van Norman Flywheel Grinder but the grinder motor which is 5HP 3600 RPM
Went Brock but I have an almost identical spare motor the only problem is that this one is 1800 RPM could someone tell what will be the difference if I'm not wrong I think the finish
Will be rough using the 1800 RPM cuz is the same horse power then I really don't know if the grinding stone will last longer or shorter.
All comments will be highly appreciated .
Best Of All to all of you guys.
TBD