Madis Reivik
Hot Rolled
- Joined
- Jan 23, 2011
- Location
- Estonia
Hello !
Please share tricks of trade.
I do the following:
1) Use diamond to make grinding wheel surface flat and clean
2) Set the zero using i.e. 10mm gage blcok between wheel and "zero" surface, by moving gage block left and right until the non-rotating wheel starts touching the block.
3) it seems to give about 2..4um of repeatibility.
Are there any better ways to set grinding height zero ? Also, I feel that my explanation in english is quite sloppy so anybody can rephrase my question correctly
I'm currently doing some ferrite E-core grinding and i get about 5um accuracy, which is good enough but I feel it could be better.
Please share tricks of trade.
I do the following:
1) Use diamond to make grinding wheel surface flat and clean
2) Set the zero using i.e. 10mm gage blcok between wheel and "zero" surface, by moving gage block left and right until the non-rotating wheel starts touching the block.
3) it seems to give about 2..4um of repeatibility.
Are there any better ways to set grinding height zero ? Also, I feel that my explanation in english is quite sloppy so anybody can rephrase my question correctly
I'm currently doing some ferrite E-core grinding and i get about 5um accuracy, which is good enough but I feel it could be better.