RonRock
Aluminum
- Joined
- Mar 18, 2012
- Location
- Underwood, IA
So I'm trying to clean up and repair a couple things that were fouled up on my J&S 540.
Couple questions before I damage things.
How do I get this shaft out? I have removed the set screw and soaked it down with PB Blaster and it still won't budge. I have buggered up the exposed end of the shaft with my pliers, but I can clean that up at this point.
Also how do I remove the large dial and the small Fine Feed dial?
I can see that these have been greased previously. Obviously with the grease zerks. Is grease here correct? Or are the zerks actually for oil like my Bridgeport was designed?
Couple questions before I damage things.
How do I get this shaft out? I have removed the set screw and soaked it down with PB Blaster and it still won't budge. I have buggered up the exposed end of the shaft with my pliers, but I can clean that up at this point.
Also how do I remove the large dial and the small Fine Feed dial?
I can see that these have been greased previously. Obviously with the grease zerks. Is grease here correct? Or are the zerks actually for oil like my Bridgeport was designed?