Hey guys,
I just bid and won a Mitsui 200MH. It was bought without an inspection So it was a bit of a crapshoot. The price paid was pretty good though.
I’m picking it up next week (a 9 hour drive each way) and need to get an idea on how to remove the table and (cable drive?). Also, with the table off, I’m thinking that I can block the spindle head to cross column were the table normally rides. I imagine it is all metric hardware and I’ll pack a small to go toolbox with wrenches, sockets, Allen wrenches and assorted hand tools. Is there any special tools I’ll need or any suggestions?
I won’t have time to get a manual befor I leave to pick it up so I’ll be winging it a bit...just don’t want to Fubar anything up.
Thanks folks,
Regards, Richard
I just bid and won a Mitsui 200MH. It was bought without an inspection So it was a bit of a crapshoot. The price paid was pretty good though.
I’m picking it up next week (a 9 hour drive each way) and need to get an idea on how to remove the table and (cable drive?). Also, with the table off, I’m thinking that I can block the spindle head to cross column were the table normally rides. I imagine it is all metric hardware and I’ll pack a small to go toolbox with wrenches, sockets, Allen wrenches and assorted hand tools. Is there any special tools I’ll need or any suggestions?
I won’t have time to get a manual befor I leave to pick it up so I’ll be winging it a bit...just don’t want to Fubar anything up.
Thanks folks,
Regards, Richard