dcsipo
Diamond
- Joined
- Oct 13, 2014
- Location
- Baldwin, MD/USA
I am honing a cylinder it is 9 " long 4" diameter. I made the hone and I am using 500 grit diamonds. I managed to hone a .001" taper into it. I have 2 adjusting crews on the hone. Am I not tightening them evenly? or not moving the hone enough? I had a different resistance on the ends and tried to balance it with the screws. Should I just have one adjustment in the center of the hone? the hone is 4" long. this is all new to me . Any practical advice would be appreciated.
dee
;-D
dee
;-D