ballen
Diamond
- Joined
- Sep 25, 2011
- Location
- Garbsen, Germany
Can someone identify the taper for these internal grinding spindle arbors? Is this a standard, so I could tell what spindles would fit it? Dimensions are listed on the photo.
By the way, the collet chuck has no identifying marks, but it's hardened and ground on all surfaces. The collet inside is Schaublin, 5-6mm.
I'd also like to know what these arbors shown below are meant for. And what's the purpose of the black screw? Again, dimensions are on the photo.
By the way, the collet chuck has no identifying marks, but it's hardened and ground on all surfaces. The collet inside is Schaublin, 5-6mm.
I'd also like to know what these arbors shown below are meant for. And what's the purpose of the black screw? Again, dimensions are on the photo.