We have a new to us Studer s40-2.
The problem we are having is when Traversing parts. The center of the shafts. (26 inches long) go .0002 to .0003 smaller than the ends. The centerline of the shafts are within .0002 from Center to center. The only thing I have found is to let the ends dwell for 4 seconds each and the more free passes the worse it gets. I feel we are losing to much time this way. We have not run into this on any other of our grinds. But the rest of our grinders this length are manual.
Any ides
The problem we are having is when Traversing parts. The center of the shafts. (26 inches long) go .0002 to .0003 smaller than the ends. The centerline of the shafts are within .0002 from Center to center. The only thing I have found is to let the ends dwell for 4 seconds each and the more free passes the worse it gets. I feel we are losing to much time this way. We have not run into this on any other of our grinds. But the rest of our grinders this length are manual.
Any ides