markp
Hot Rolled
- Joined
- Oct 7, 2006
- Location
- Petaluma CA 94952
Ive got a 2013 Supertec Planotec 2040NC surface grinder. Turned it on today after it sat a few weeks and now the servo motor that operates the infeed/outfeed does not work. The servo for the head up/down works fine. The PLC control uses the cross feed motor to index the table when running a program. Also, the manual feed thats needed to set the limits for a job dont work either. The manual feed buttons for cross dont light up as they are supposed to. If you try to run a program, the machine does not move in cross and stops after a few table back and forth cycles. No error on the control.
I keep the machine powered off when not in use and also keep the power disconnected from the cabinet when not in use so there were no surges. Its a simple PLC type control with a few canned cycles. Never had any problems with it since Ive owned it over the last year and a half. Anyone with one of these have any idea of how to get this going again? Supertec tech support is not so super so I dont have much hope there, but I was going to call them tomorrow in any case.
I keep the machine powered off when not in use and also keep the power disconnected from the cabinet when not in use so there were no surges. Its a simple PLC type control with a few canned cycles. Never had any problems with it since Ive owned it over the last year and a half. Anyone with one of these have any idea of how to get this going again? Supertec tech support is not so super so I dont have much hope there, but I was going to call them tomorrow in any case.