I would like a couple washers made and wondered if any members are available for hire on a small project.
The washer measurements and material desired are as follows:
Stainless Steel
.060 thick
O.D. of .750
I.D. of .445
Here are some images that illustrate how and where the washer will be used. The jam nut is starting to cut/dig into the bearing wall surface and I think a washer will prevent this from getting worse.
The washer measurements and material desired are as follows:
Stainless Steel
.060 thick
O.D. of .750
I.D. of .445
Here are some images that illustrate how and where the washer will be used. The jam nut is starting to cut/dig into the bearing wall surface and I think a washer will prevent this from getting worse.