Hi..
Have finally begun working on my #5 gap bed lathe..
I notice that a steel and aluminium thrust bearing has been placed on the rear of the spindle.. this moved the spindle forward until the bull gear was touching the headstock. allowance has then been made(with cold chisel and grinder) to allow the bull gear to turn.
The threaded brass bush has some play, so will need replacing..
Your thoughts ..
Ken
Have finally begun working on my #5 gap bed lathe..
I notice that a steel and aluminium thrust bearing has been placed on the rear of the spindle.. this moved the spindle forward until the bull gear was touching the headstock. allowance has then been made(with cold chisel and grinder) to allow the bull gear to turn.
The threaded brass bush has some play, so will need replacing..
Your thoughts ..
Ken