What's new
What's new

Glaze material

Froneck

Titanium
Joined
Dec 4, 2010
Location
McClure, PA 17059
I picked-up a Portage HBM at HGR. Looks to have been hardly used. All ways are in excellent condition, all scraping/frosting still very visible. I'm painting it but on the headstock where operator controls are I used a wire wheel to remove old paint, not sure if headstock was glazed but there are casting pits in the surface and I would like to smooth it before spray painting. What would be best to use, can I use it on bare metal or should I prime it first?
 
Bondo body repair filler. Mix, spread...wait @ 10 minutes and lightly file..then after 30 minutes from spreading you can sand and paint. Quick and easy to use. Check out some YouTube videos then go to almost any hardware store and buy some Bondo.
 








 
Back
Top