stevewatr
Stainless
- Joined
- Aug 9, 2013
- Location
- Worcester County, Massachusetts
Anybody know the maker??
Picked up this old fixture cheap ($25), well, seemed cheap enough at the time lol.
I figure it was for sharpening endmills.
Damage around the nose area suggests it was used on a T&C grinder.....a lot!
The detent ring is marked 24T, so I guess it probably came with a set of these with different divisions.
Other than the graduation Mark's for the angles, only markings I could see is stamped into one of the lands. My best guess is GF3LAX.
The go leg handle appears to have been an afterthought, but is not without merit.
I figure I'll clean it up, and keep it handy. Maybe I'll even make some more detent wheels.
Steve W.
Sent from my SM-J737P using Tapatalk
Picked up this old fixture cheap ($25), well, seemed cheap enough at the time lol.
I figure it was for sharpening endmills.
Damage around the nose area suggests it was used on a T&C grinder.....a lot!
The detent ring is marked 24T, so I guess it probably came with a set of these with different divisions.
Other than the graduation Mark's for the angles, only markings I could see is stamped into one of the lands. My best guess is GF3LAX.
The go leg handle appears to have been an afterthought, but is not without merit.
I figure I'll clean it up, and keep it handy. Maybe I'll even make some more detent wheels.
Steve W.
Sent from my SM-J737P using Tapatalk