Froneck
Titanium
- Joined
- Dec 4, 2010
- Location
- McClure, PA 17059
My lathes are level, I have all the Starrett precision levels, shortest to the longest in addition to the super precision level so I'm not using a Carpenters level! (Yes I'm a tool junkie, I think it would be cheaper if I was a druggie on the other hand maybe tools took all my money so I couldn't afford drugs )
From time to time I need to adjust my tail stock to remove slight taper (.003 to .004"/6" sometime more or less but not much.
Naturally the tail stock is clamped in location, so what is the "approved" or best way to make the adjustment?
From time to time I need to adjust my tail stock to remove slight taper (.003 to .004"/6" sometime more or less but not much.
Naturally the tail stock is clamped in location, so what is the "approved" or best way to make the adjustment?