Mau5trap91
Plastic
- Joined
- Jan 18, 2019
New to PM so first off hi everyone.
Just traded a furnace install for a 1920ish 16x8 Hendey conehead lathe, was in the market for a new project and the guy had it buried in car parts so I figured it was worth asking if he would part with it.
It has an under powered 3/4 horse on a 3 speed tractor transmission, the mount won’t let you switch speeds due to location, and it needs some tlc but it spins free.
I found a few numbers on it in various locations but can’t find anything stamped in the ways.
Going to get it oiled up and swap out the motor and I figured this may be a good place just to document the project.
Attempting to upload pictures
Just traded a furnace install for a 1920ish 16x8 Hendey conehead lathe, was in the market for a new project and the guy had it buried in car parts so I figured it was worth asking if he would part with it.
It has an under powered 3/4 horse on a 3 speed tractor transmission, the mount won’t let you switch speeds due to location, and it needs some tlc but it spins free.
I found a few numbers on it in various locations but can’t find anything stamped in the ways.
Going to get it oiled up and swap out the motor and I figured this may be a good place just to document the project.
Attempting to upload pictures