I recently acquired a Pratt & Whitney #3 Bench Milling Machine. I'm not a machinist but it's something I've always been interested in and wanted to learn. I was smart enough not to try and fire it up, it's sat for at least 10 years. Everything seems to move and turn smoothly but it's tight as in needs to be cleaned and lubed. I don't even know the proper terms for for most of the parts so don't slap me too hard. In order to move it I had to partially disassemble it. I was able to remove the table? from the column? without too much problem, unbolt everything from the bench and move it. It was raining so it also got a bit wet. From what I could see there was a putty type substance around the gears that I'm sure was grease many years ago. I could figure out how to remove the spindle? and further disassembly of the table didn't seem like a good idea without some guidance. It's missing some things, there's only 3/8 and 1/2 collets?, a few arbors and some cutters but it dose have a dividing head? and some other parts. Any advise (other than offers to take it off my hands )?