Mike Hill
Cast Iron
- Joined
- Aug 28, 2004
- Location
- upper michigan
I purchased a 20 inch Rockford shaper this summer and I was wondering if it is normal for the ram to not start right away after you throw the lever, mine seems to take about a minute for it to get moving then after that it seems to travel fine but I believe it’s not putting the power to the tool that it should, stuck relief? The machine has probably sat all its life, it has a U.S. strategic reserve tag on it and a college tag on it, and I bought it from the same spot it sat unpowered the last 20 years.