I have just acquired a 20" Smith & Mills shaper... I don't know when it was manufactured, but I'm guessing it would be one of the later ones.
The main drive motor is a 5hp GE 220/440v 3 phase... currently wired for 440v. The rapid traverse motor is significantly smaller, but the data plate is missing from it, so I have no information on whether it is a single phase, 3 phase, hp rating, etc...
Some of this info I can probably figure out after I get into the electrical system, but I was hoping someone here has a 20" S & M and could provide me with this info... or a picture of the data plate would be great...
There doesn't seem to be a lot of info available for this machine, so I know this is a long shot...
Thanks- Bear
The main drive motor is a 5hp GE 220/440v 3 phase... currently wired for 440v. The rapid traverse motor is significantly smaller, but the data plate is missing from it, so I have no information on whether it is a single phase, 3 phase, hp rating, etc...
Some of this info I can probably figure out after I get into the electrical system, but I was hoping someone here has a 20" S & M and could provide me with this info... or a picture of the data plate would be great...
There doesn't seem to be a lot of info available for this machine, so I know this is a long shot...
Thanks- Bear