chippinchunks
Aluminum
- Joined
- Oct 11, 2016
- Location
- San Diego
HI everyone. This is the apron on my sb13. The previous owner drilled oil holes all over this apron. The 2 that I am most concerned with are shown in the pictures. The apron is cast iron and my concern is it fracturing in the areas that have been drilled through over time. I figure there's a reason why this wasn't done at the factory. Now that I have the apron apart should I just replace it with another one or do you think it will hold up as is? Thanks for your input.
Martin
Martin