rustytool
Stainless
- Joined
- Oct 27, 2010
- Location
- Moscow,Idaho,USA
Found this on craigslist 45 miles away. How could I resist ?
Painted a few times and rusting away I disassembled and stripped off all the layers of paint.
The table ways still have most of the hand scraping. Someone had replaced the overhead pulley bushings with shielded bearings so I replaced all the other open ball bearings with shielded ones. Except for the two roller bearings that the table drive shaft slides on.
Repainted with Sherwin Williams Polane. Though I've never seen any paint that can take the abuse that a grinder will throw at it.
Painted a few times and rusting away I disassembled and stripped off all the layers of paint.
The table ways still have most of the hand scraping. Someone had replaced the overhead pulley bushings with shielded bearings so I replaced all the other open ball bearings with shielded ones. Except for the two roller bearings that the table drive shaft slides on.
Repainted with Sherwin Williams Polane. Though I've never seen any paint that can take the abuse that a grinder will throw at it.