Dr. Hillbilly
Aluminum
- Joined
- Dec 6, 2019
- Location
- Oregonia, Ohio
I need to tool up my Hendey-Norton No. 2
The machine came with 3 arbors but only one shell-mill holder (1-1/2") and no collets.
I can find collets for B&S #7 spindles and B&S #9 (shown below), but none for #10
Of course there are a lot of #10 collets for the B&S screw machines but that is a completely different collet (short non-locking taper in front, a little like the R-8)
There are also #10 feed-fingers for the screw machines, but not what I need.
The machine came with 3 arbors but only one shell-mill holder (1-1/2") and no collets.
I can find collets for B&S #7 spindles and B&S #9 (shown below), but none for #10
Of course there are a lot of #10 collets for the B&S screw machines but that is a completely different collet (short non-locking taper in front, a little like the R-8)
There are also #10 feed-fingers for the screw machines, but not what I need.