Alignment Pin Removal on Lyman Bullet Molds

Webb Wyman · Apr 5, 2004

Hi There,

Can someone tell me if the alignment pins on Lyman bullet molds are pressed in or threaded in?

Thanks in advanced!
Webb

Buckshot · Apr 5, 2004

........Pressed.

Best,
Rick

Paul_Gauthier · May 12, 2004

There was an ealier thread on this subject but I don't remember which bbs. They are pressed, if removing try not to use a steel punch as you could mushroom the end and cause alignment problems.

Paul G

quasi · May 13, 2004

Use ana arbor press and a proper size punch preferably mounted to the ram of the press.

Search

Largest Manufacturing Technology Community on the Web

Search

Alignment Pin Removal on Lyman Bullet Molds

Webb Wyman

Stainless

Buckshot

Cast Iron

Paul_Gauthier

Cast Iron

quasi

Stainless

Similar threads