Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Brass Nut Quote
- Thread starter Nesconset
- Start date
- Replies 3
- Views 912
Claude
Aluminum
- Joined
- May 23, 2006
- Location
- Manitowoc WI.
How soon do you need them, is this a one time deal or return job. Will material be supplied and finally will you need these chrome plated. Send me an e-mail with print at [email protected] if still interested in a quote.
Best Regards
Claude
Best Regards
Claude
SteelCutter
Hot Rolled
- Joined
- Oct 21, 2006
hey Claude, have you looked @ the date of this RFQ?
Maybe it is still open, but I doubt it!
also, the big SS flanges you asked about. from this buyer as well, that is from April, 3 months ago, I looked into that one, I established communications with the buyer 'til I got the quote back on the material cost ((material cost alone will send you to the poor house,)) one chunk alone was like $700.00
best wishes!
SteelCutter
Maybe it is still open, but I doubt it!
also, the big SS flanges you asked about. from this buyer as well, that is from April, 3 months ago, I looked into that one, I established communications with the buyer 'til I got the quote back on the material cost ((material cost alone will send you to the poor house,)) one chunk alone was like $700.00
best wishes!
SteelCutter
Claude
Aluminum
- Joined
- May 23, 2006
- Location
- Manitowoc WI.
Hey SteelCutter,
I guess I did look at the date but notice that there were no response to the RFQ that was the only reason I post it. I have not been on this site for ages so I have to get back in the groove. as far as the SS flanges I see what you mean as far as the poor house. I only have a 5000 Sq. foot facility with about 20 machines so you can imagine how I must keep my budget tight. Thanks for the info.
Claude
I guess I did look at the date but notice that there were no response to the RFQ that was the only reason I post it. I have not been on this site for ages so I have to get back in the groove. as far as the SS flanges I see what you mean as far as the poor house. I only have a 5000 Sq. foot facility with about 20 machines so you can imagine how I must keep my budget tight. Thanks for the info.
Claude
Similar threads
