MwTech Inc
Titanium
- Joined
- Feb 6, 2005
- Location
- Fishersville VA
Looking for someone to make the gear on the right in the picture. gear
Rough specs are 2.250 od///1.065 id///.625 thick. 28 teeth on gear.
The pins are .250. The gear on the left shows how the gear is supposed to look, tooth wise. The OEM is real tight on giving out any info, so I can't tell you what pitch etc. Need the worm cut and the three holes made for the pins[press fit on the pins]. Need one to start, however there is a real good chance to need more. What I need now is an approximate cost.
Thanks
[ 08-08-2007, 07:20 AM: Message edited by: Mwt Inc / Andy ]
Rough specs are 2.250 od///1.065 id///.625 thick. 28 teeth on gear.
The pins are .250. The gear on the left shows how the gear is supposed to look, tooth wise. The OEM is real tight on giving out any info, so I can't tell you what pitch etc. Need the worm cut and the three holes made for the pins[press fit on the pins]. Need one to start, however there is a real good chance to need more. What I need now is an approximate cost.
Thanks
[ 08-08-2007, 07:20 AM: Message edited by: Mwt Inc / Andy ]
