emt2688
Cast Iron
- Joined
- Mar 6, 2006
- Location
- NE Nebaska
I need help programming a simple cavity in Mastercam.
Probably the best way is to have one of you just program from a MC9 file that I would e-mail you. Then I can see how you went about cutting the cavity (which type of cycle you would use, ect.)
This would be a simple 2 tool cut path, 1/2" 2 flute end mill and 1/2" 2 flute ball end mill. Material is aluminum.
The part requires 20 cavities, but I can transform the tool paths, so I just need one cavity programmed.
Email me if you interested in helping a dummy out. [email protected]
Thanks
Probably the best way is to have one of you just program from a MC9 file that I would e-mail you. Then I can see how you went about cutting the cavity (which type of cycle you would use, ect.)
This would be a simple 2 tool cut path, 1/2" 2 flute end mill and 1/2" 2 flute ball end mill. Material is aluminum.
The part requires 20 cavities, but I can transform the tool paths, so I just need one cavity programmed.
Email me if you interested in helping a dummy out. [email protected]
Thanks