tobydbaker74
Aluminum
- Joined
- Sep 8, 2018
- Location
- Columbus
This machine has been down for a week. It went to tool change and stopped and alarmed out. The operator did not pay attention to the alarm and powered off and on, After it homed out the X and Y and now will not reference the turret. I was talking to Hardinge for the last week and the last thing I was emailed was it probably rusted and got stuck. Then I emailed and said its not rusted and they referred me to Gosiger repair in Dayton. They have been extremely helpful in trying to help.
Today I took the cover off the turret and found one lose wire on the X4 cable from the Duplomatic controller. I reattached the yellow wire that was labeled number 10. Still will not reference the turret. Gosiger says they believe its lost its position and I need a cable to hook into the Duplomatic drive to see what is going on. I have a Duplomatic Program to communicate with the drive called DTI 2.6 lite but no cable. Does anyone know where I can get this cable or a way to manually reference it in the control. It is a Oi-TB control. or does anyone know any repair places that specializes in these. Gosiger services them but send out the turrets and drives which I cant afford to be down that long. The Duplomatic drive is a DDC-4 btw.
Any help would be greatly appreciated
Today I took the cover off the turret and found one lose wire on the X4 cable from the Duplomatic controller. I reattached the yellow wire that was labeled number 10. Still will not reference the turret. Gosiger says they believe its lost its position and I need a cable to hook into the Duplomatic drive to see what is going on. I have a Duplomatic Program to communicate with the drive called DTI 2.6 lite but no cable. Does anyone know where I can get this cable or a way to manually reference it in the control. It is a Oi-TB control. or does anyone know any repair places that specializes in these. Gosiger services them but send out the turrets and drives which I cant afford to be down that long. The Duplomatic drive is a DDC-4 btw.
Any help would be greatly appreciated