Josh, your program title sucks. Per forum rules, it does not say anything about what you are asking. Your question is even so open ended as to cause confussion. I'll leave up for a while and see if you can provide more detail as to what you need. Your question as it reads now is akin to "my car won't run".
JR
When i go in to stepconf wizard in linuxcnc and try to get the stepper motors for the xyz to move i cant get them to do anything and im not sure what to put in to get them working
This sounds like a home brew system. There are other forum out there that can maybe help you. I seriously doubt that you'll get any help from this group. I think this might be a better place for you to start: Index - LinuxCNC
JR
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.