I am new to the EZTrak 3-axis So I powered it up today and got this error message shown in the picture.
Does this machine have a special torque wrench to engage or disengage the z- axis? I don't have one so can I use
a a different torque wrench? What is the torque spec?
Don't know for sure, but by the warning, it looks as if your quill is locked.
Do you have a manual? I'm just betting that's a NO. Southwestern Industries, Inc.
JR
Thanks for the feed back. The message is just a warning message to go from 3 to 2 axis. To make sure the clamp is tightened for 3 axis or loose for 2 axis mode. I guess i will have to get a little torque wrench.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.