mvernon
Plastic
- Joined
- Feb 10, 2019
- Location
- Pennsylvania
Hello All,
I am sure this has to have been covered in another forum so please link if that is so. But, my Bridgeport J Head round ram seems to be catching a little bit when putting into back gear. If I place a 10 thou shim between the cam ring and the housing that will provide enough clearance. What is the typical solution to this, as the shim will fall out when rotating the cam ring in and out?
Thoughts?
Thanks!
Matt
I am sure this has to have been covered in another forum so please link if that is so. But, my Bridgeport J Head round ram seems to be catching a little bit when putting into back gear. If I place a 10 thou shim between the cam ring and the housing that will provide enough clearance. What is the typical solution to this, as the shim will fall out when rotating the cam ring in and out?
Thoughts?
Thanks!
Matt