Jazeleng
Plastic
- Joined
- Oct 11, 2012
- Location
- South Africa
I hope someone can help with this, I had a jerking Y axis and after searching the forums most people advised me to change the brushes and blow the carbon out the servo motor, that didnt help this time so I opted to take a servo motor from a identical spare machine and fit it. But now it rams against the end when it is suppose to move over the reference points, then a friend said that the encoder dosnt know where the table is now and that i should loosen the servo pulley and turn the pulley a few degrees till it stops doing it, well that worked but now it keeps on giving the message "Wrong reference point"!!!