Monomer
Cast Iron
- Joined
- Dec 11, 2006
- Location
- Detroit, MI
I've just bought a 1956 1J bridgeport off of a fellow coworker.
It looks to have had a hydraulic tracer setup on the knee, added much later in it's life. Still have the provisions for a knee lift handle, but it's not splined like a normal BP, despite coming with a normal BP handle. Does anyone know off hand which pieces need replacing and where to source them? (I'll post pics tomorrow)
I think I narrowed it down to two different VFC's:
WJ200-007SF 1HP .7kW 230V Single Phase Input VFD - Hitachi
https://www.amazon.com/Teco-Variabl...=B01J8K4LSY&psc=1&refRID=TV180BGZ413SACRWF2GK
Are these the goto for a 1hp step-pulley? or should I be looking for an AB unit on ebay? I have 50 amps of 220 single phase on a dedicated circuit already wired up.
It looks to have had a hydraulic tracer setup on the knee, added much later in it's life. Still have the provisions for a knee lift handle, but it's not splined like a normal BP, despite coming with a normal BP handle. Does anyone know off hand which pieces need replacing and where to source them? (I'll post pics tomorrow)
I think I narrowed it down to two different VFC's:
WJ200-007SF 1HP .7kW 230V Single Phase Input VFD - Hitachi
https://www.amazon.com/Teco-Variabl...=B01J8K4LSY&psc=1&refRID=TV180BGZ413SACRWF2GK
Are these the goto for a 1hp step-pulley? or should I be looking for an AB unit on ebay? I have 50 amps of 220 single phase on a dedicated circuit already wired up.