I now have more than one machine that
runs on 3 phase and will probably wind
up with more.
I like the ability of being able to
adjust the spindle speed on the fly
of my step pulley head. Can I run the
Lenze VFD in conjunction with a phase
converter for this purpose?
I now have more than one machine that
runs on 3 phase and will probably wind
up with more.
I like the ability of being able to
adjust the spindle speed on the fly
of my step pulley head. Can I run the
Lenze VFD in conjunction with a phase
converter for this purpose?
MOST of the VFD's in industrial use, worldwide, are powered from 3-Phase. They like it better than single-phase! Even poorly-balanced RPC 3-P is easier on them that single-phase, so "yes, generally".
"Mixing" VFD and direct off the RPC 3-phase, same machine-tool & controls, is what you need to be careful with.
Any mill with but one load-motor should not be complicated.
Separate juice-pump or feed motors KEPT "separate" should be OK as well.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.