Chris Davis
Plastic
- Joined
- Jun 4, 2016
Hello, I am trying to get my new to me EZ-Trak Series 1 mill running. The X-Axis cable (P/N 1939934) appears to be damaged. I have not removed it completely yet to complete testing it. I see damage to the connector and was able to get the X-Axis to home once. It acts like it is not getting a signal that the motor is turning unless I hold the cable in just the right way.
I found the connector on online for about $30. Any suggestions on where to get the cable? I am not sure what cable to buy. Also, where would I source the connector at the Power Amplifier.
I need to find a thread where someone has replaced / repaired the motor control cables.
Thanks
I found the connector on online for about $30. Any suggestions on where to get the cable? I am not sure what cable to buy. Also, where would I source the connector at the Power Amplifier.
I need to find a thread where someone has replaced / repaired the motor control cables.
Thanks