machine aviator
Plastic
- Joined
- Oct 17, 2020
DUH, I see now that there are two threaded holes just below the chip tray on the back of the machine. I guess I should look more carefully before posting. I have almost everything up and running on my new HLV; however, I can't figure out how the chip and coolant shield is supposed to be attached. It came with the lathe and it would be nice to get it cleaned up and attached. It shows in the catalog as "tool number L-14" and has three rods going left to right and a plexiglas wing on the right side. Does anyone have a picture of how it is supposed to be attached or a reasonable explanation. All it has on the bottom are a couple of "L" brackets that don't seem to be long enough to attach to anything.
Always appreciate the advice.
Thanks
Dave
Always appreciate the advice.
Thanks
Dave
Last edited: